10 selectable blink sequences - Click HERE to see them!
-
50 selectable speeds from 10ms to 500ms in 10ms increments
-
Special Lane Change mode will sequence rear blinkers 3 times when the turn signal is tapped once. Can be set either on or off.
-
Special Brake Flash/Splash mode, will Flash or Splash the brake lights 3 times when the brake pedal is pressed. Will wait 8 seconds after either the brake or turn signals are used before doing it again. Can be set to either Flash, Splash or normal brake lights.
-
High current MOSFET technology means full lamp brightness
-
3rd Brake light output if you want to hook one up for safety
-
Microcontroller based for future upgrades or custom blink sequences
-
Fits in original sequencer housing after removing old sequencer board - can be returned to orginal, just keep your parts
-
2 pushbuttons set sequence, speed, lane change and brake splash modes. Holding both buttons returns system to original Ford factory setting. EEPROM stores and remembers last settings
-
LED's indicate blink pattern, program settings, and input signals from the turn signals and brake pedals for easy install troubleshooting.
-
Remote programming board and monitor allows you to make adjustments from within the car,trunk, or wherever you want. Also doubles as a rear blinker monitor and indicator.
-
Easy install - because of the original Ford design, it is necessary to run a 2 conductor wire from the lower steering column to the trunk, hook up a power lead, and unhook a connector behind the glove box - easier than installing a car stereo and your car remains unaltered.
-
Works with a broken turn signal switch. If your turn signal switch is burnt, but your cornering lights and front signals still work then this unit will function since it only needs the cornering light output signal to engage. You can also use any inexpensive blinker 'can' since the rear blinkers are now controlled by the sequencer.
-
Click HERE for installation instructions
-
50 selectable speeds from 10ms to 500ms in 10ms increments
-
Special Lane Change mode will sequence rear blinkers 3 times when the turn signal is tapped once. Can be set either on or off.
-
Special Brake Flash/Splash mode, will Flash or Splash the brake lights 3 times when the brake pedal is pressed. Will wait 8 seconds after either the brake or turn signals are used before doing it again. Can be set to either Flash, Splash or normal brake lights.
-
High current MOSFET technology means full lamp brightness
-
3rd Brake light output if you want to hook one up for safety
-
Microcontroller based for future upgrades or custom blink sequences
-
Fits in original sequencer housing after removing old sequencer board - can be returned to orginal, just keep your parts
-
2 pushbuttons set sequence, speed, lane change and brake splash modes. Holding both buttons returns system to original Ford factory setting. EEPROM stores and remembers last settings
-
LED's indicate blink pattern, program settings, and input signals from the turn signals and brake pedals for easy install troubleshooting.
-
Remote programming board and monitor allows you to make adjustments from within the car,trunk, or wherever you want. Also doubles as a rear blinker monitor and indicator.
-
Easy install - because of the original Ford design, it is necessary to run a 2 conductor wire from the lower steering column to the trunk, hook up a power lead, and unhook a connector behind the glove box - easier than installing a car stereo and your car remains unaltered.
-
Works with a broken turn signal switch. If your turn signal switch is burnt, but your cornering lights and front signals still work then this unit will function since it only needs the cornering light output signal to engage. You can also use any inexpensive blinker 'can' since the rear blinkers are now controlled by the sequencer.
-
Click HERE for installation instructions
